MP5 9MM Trip Slip is 3D printed in PLA Pro as suggested from the creators so be carful when installing, there is many help online but I’ll do my best to give you some tips.

Phone Number is listed on the main page for questions about your order.

The slip trip is nothing more then a trip "bar" for the MP5 platform that enables most
if not all mp5s and clones to work with ar15 parts that require a full auto bolt carrier
like the super safety or SFFA.

The slip trip functions by sliding on the rails of the receiver while being pulled by the
bolt carrier, it doesn't require any special modifications and will work with any bolt
carrier including semi only cut BCs. When a round is fired and the bolt carrier comes
back the slip trip will collapse on itself so it wont have any noticeable affect on
rate of fire, recoil impulse and will not create additional wear on the receiver.

was c

Below is from the designers of the trip slip

----------Warning about metal slip trips------------

The printed slip trip is designed around pla pro not metal so making it
in metal will end up making it weigh at least 6x as much as one printed
in pla pro. The durability of a printed slip trip should be well past
1000 rounds even with below average print settings. Good print
settings in something like nylon that is printed slow, hot and then
annealed should outlast any metal SS cam currently on the market.

This added weight from making the slip trip in metal can cause the
slip trip to slam forward into the lever potentially damaging the SS
lever or CAM. I would recommend you all to just print slip trip in PLA
pro or nylon as intended.

------Disclaimer---------

Note: that if your are using a AP5 or AP5K the slip trip will most likely need to be
filed in some areas to fit past the full auto bolt carrier group block.

This is a 3 Position Super Safety, this device force resets the trigger from the Bolt carrier group using the lever that is on the cam. When installed and tuned correctly it will allow faster follow up shots, this is not a Machine Gun Conversion device. This is classified as a ATS ( Active Trigger System) it is designed by Hoffman Tactical, I do not claim to be the creator. You can find many of help on YouTube how this works and how to install it to make it run.

Items in each kit

1-Stainless Steel Cam

1-Stainless Steel Lever

1-Rounded Detent

1-Trigger Jig

1-PLA Pro Trip Slip MP5 9MM